Designer Cut WraithVeil® Dual Front Rear Projector Screen for Halloween
It's perfect! It works very well! The only thing is that the screws were very cheap and broke when we were hanging it up so I had screws around the house I used instead but other then that it was a peice of cake. I recommend it. It's also very cheap
Does the job, included mounting gear allows for adjusting after install, I paired it with an elite screen and it fit well I can see these working with other screen brands too. Would buy again.I guess I should note that I was mounting on brick and I didn't use the included anchor or screws.
This is a much more secure option rather than mounting the screen directly to the wall.It allows a large gap between the wall and screen to allow space for a TV or anything else that would otherwise obstruct a projector screen.I used them with an 80' screen. Do not use drywall anchors. Mount it to the stud. Otherwise, constant retraction of the screen can AND WILL weaken the drywall, possibly causing it to fall.This happened to me. The reason I'm not leaving a bad review is because I should have known better. I mounted them too a 1x4x60 board after. 3" screws to hold the board, and (2) 1" screws on either side to hold the brackets. This way you have the support of studs when they don't line up.
